Table of Contents
Advertisement
4.
With the control panel facing the same way as the power source front panel, place the wire feeder in the cor-
responding grooves on the wire feeder rotating plate.
5.
Slide the wire feeder from front to back until the bar in the back of the unit locks to the orange claw at the back of
the wire feeder rotating plate.
2.3.2 Installing welding gun holder
Install the welding gun holder to either side of the wire feeder.
Proceed as follows:
1.
Install the welding gun holder mount to the wire feeder with 2 screws going to the corresponding holes on the wire
feeder upper cover hinge.
2.
Attach the welding gun holder to the mount with 2 screws.
2.3.3 Replacing feed rolls
Replace the feed rolls when the material and diameter of the filler wire changes.
Proceed as follows:
© Kemppi
33
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
