4.1 Daily maintenance
Disconnect the power source from the mains before handling electrical cables.
Maintenance of power source and wire feeder
Follow these maintenance procedures to maintain the proper functioning of the welding system:
•
Check that all covers and components are intact.
•
Check all the cables and connectors. Do not use them if they are damaged and contact service for replacements.
•
Check the wire feeder's feed rolls and the pressure handle. Clean and lubricate with a small quantity of light
machine oil if needed.
Maintenance of Control Pad
Control Pad is water resistant and can be wiped clean with a moist cloth. Do not use detergents.
For repairs, contact Kemppi at
Welding gun maintenance
For information on Flexlite GX MIG welding gun maintenance, refer to userdoc.kemppi.com.
© Kemppi
www.kemppi.com
or your dealer.
129
X8 MIG Welder
Operating manual - EN
1902370 / 2324