Welding Data Collection: Entering Information About Non-Welding Activity - Kemppi X8 MIG Welder Operating Manual

Figure: The welder is not qualified for welding with the selected WPS
Control Pad shows the welding current and voltage during welding and indicates whether the values are within the lim-
its of the WPS. This information may be useful for the bystanders observing the welding. The values are shown in white,
yellow or red.
White: The measured value is within the WPS limits or the WPS is not identified.
Yellow: The measured value is near the WPS limits. (Warning)
Red: The measured value is outside the WPS limits. (Alert)
There is a short reaction time, usually a few seconds, before the color changes. This makes the display easier to read and
enables monitoring of the overall welding quality.
For more information, see WeldEye help on Real-time WPS monitoring.

Welding data collection: entering information about non-welding activity

The device uses activities to track non-welding time or events causing pauses in the production. Activities are divided
into expected pauses (for example, lunch breaks) and unexpected pauses (for example, waiting for a material delivery).
Activities are defined in the WeldEye cloud service, and you can identify bottlenecks in your production with them.
Select an activity with Control Pad. WeldEye registers and stores the code.
Proceed as follows:
© Kemppi
121
X8 MIG Welder
Operating manual - EN
1902370 / 2324