Table of Contents
Advertisement
Figure: WiseThin+ Welding view
When using WiseThin+, depending on the welding program, you can adjust the following welding parameters through
Settings > Parameters:
•
Wire feed speed
>> min: adjusts the minimum set value for wire feed speed
>> max: adjusts the maximum set value for wire feed speed
•
Fine tuning: adjusts the voltage (arc length).
•
Dynamics: -10...+10. Adjusts the short circuit behavior. On the minus side, the arc is softer (less spatter). On the plus
side, the arc is harder (the arc is more stable).
•
StartPower: -30...+30. Adjusts the power level for arc ignition.
•
StartLevel: -30...+30. Finetunes the arc length for arc ignition.
•
StopPower: -30...+30. Adjusts the power level for arc stop.
Wise features
Kemppi Wise features improve the quality of welds. For more information on Wise products, visit www.kemppi.com.
"Wise features: introduction to WiseFusion" below
"Wise features: using WiseFusion" below
"Wise features: introduction to WiseSteel" on the next page
"Wise features: using WiseSteel" on the next page
"Wise features: introduction to WisePenetration+" on page 97
"Wise features: using WisePenetration+" on page 97
Wise features: introduction to WiseFusion
The WiseFusion welding function enables adaptive arc length control, which keeps the arc optimally short and focused.
WiseFusion increases the welding speed and penetration and decreases heat input. WiseFusion can be used throughout
the power range (short arc, globular arc, spray arc and pulsed arc). WiseFusion is compatible with 1-MIG, Pulse and
DPulse welding processes.
Wise features: using WiseFusion
© Kemppi
95
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
