Standard Mig Welding Processes In X8 Mig Welder - Kemppi X8 MIG Welder Operating Manual

If you select the MIG mode, you can see a list of filters (for example, Material and Wire material) under the title Welding
program.
Select appropriate filters to narrow down the list of welding programs. You will see the programs matching your filter
selection as the last item on the list. It is possible that there is just one program matching your filter selection.
The MMA and GOUGING modes just have one pre-installed welding program each.

Standard MIG welding processes in X8 MIG Welder

The processes described in this chapter are available when the MIG mode is selected. For more information on selecting
the MIG mode, see "Selecting welding program" on the previous page.
The easiest way to take a certain process into use is to select a memory channel with a welding program that uses that
process. For more information, see "Control Pad views: Channel" on page 69.
The list of adjustable welding parameters in Settings > Parameters varies according to the selected welding program.
MIG
MIG is a conventional 2-knob MIG/MAG welding process that enables adjusting the wire feed speed and voltage inde-
pendently. MIG does not support the Wise features.
To adjust the wire feed speed, in the Control Pad's Welding view, turn the left knob.
To adjust the voltage, in the Control Pad's Welding view, turn the right knob.
© Kemppi
88
X8 MIG Welder
Operating manual - EN
1902370 / 2324