Wire Feeder Views - Kemppi X8 MIG Welder Operating Manual

You can press the Power button to lock the wire feeder and avoid starting welding accidentally.
The wire feeder has a memory channels button on the left and the Settings button on the right side of the display. Press
these buttons to change the view on the wire feeder's display. Press the button again to return to the Welding view.
Use the knobs under the display to move focus in the display and to adjust the values. When there is a green light in the
center of the knob, the knob also functions as a push button.
In the Welding view, adjust the welding power with the left knob and the fine tuning with the right knob. In most weld-
ing processes, this secondary parameter is voltage.
In all other views, move up and down in the menus with the right knob. Press the green button in the center of the knob
to open an item.

Wire feeder views

Welding view
In the Welding view, you can:
• See an overview of the settings of the selected welding program
• Adjust the main parameters (welding power and fine tuning)
1. Memory channel
2. Welding power
>> The unit of the parameter varies according to the welding process.
3. Voltage
Not all processes have this parameter.
4. Fine tuning
>> The unit of the parameter varies according to the welding process.
5. Applied settings displayed in symbols
>> For more information on symbols, see
Adjust the welding power with the left control knob.
© Kemppi
Kemppi symbols.
71
X8 MIG Welder
Operating manual - EN
1902370 / 2324