Table of Contents
Advertisement
1.
Open the top cover and lift the pressure handle.
2.
Push the collars on the mounting pins of the feed rolls up to pull the mounting pins off.
The mounting pins are different: The drive rolls' mounting pins have a circular mark on the top, while the pressure
rolls' mounting pins have no marks. The pressure rolls' mounting pins have central axles attached to them, so the
drive and pressure rolls' mounting pins cannot be confused with each other.
3.
Remove the feed rolls.
4.
Select the feed rolls according to the tables below.
WIRE FEED ROLLS, PLASTIC
Filler wire mater-
ial
© Kemppi
Filler wire diameter
Feed roll profile
(mm)
Feed roll iden-
tification
34
X8 MIG Welder
Operating manual - EN
Drive roll
Pressure roll
code
code
1902370 / 2324
Advertisement
Table of Contents
