Installing Optional Gas Cylinder Cart - Kemppi X8 MIG Welder Operating Manual

4. When the wheels are attached, lift the power source off the pallet.
If your setup includes X8 Gas Cylinder Cart, proceed to "Installing optional gas cylinder cart" below.

2.2.2 Installing optional gas cylinder cart

To transport a larger gas cylinder with the power source, install X8 Gas Cylinder Cart. For detailed instructions, see X8
Gas Cylinder Cart Mounting Instructions. If your setup does not include the gas cylinder cart, proceed to "Installing
optional X8 Cooler" on page 29.
1. Remove the packaging from the sides but leave the power source resting on the pallet.
2. Attach a wheel set to the front of the unit.
>> To have turning wheels in the front and the back, install the front wheel assembly to the front of the unit. For
more information, see "Installing wheels" on page 23.
>> To have fixed wheels in the front, install the rear wheel assembly to the front of the unit. For more information,
see "Installing wheels" on page 23.
© Kemppi
26
X8 MIG Welder
Operating manual - EN
1902370 / 2324