Table of Contents
Advertisement
18.
Press Wire inch to drive the filler wire to the welding gun's contact tip. To speed up the wire feed speed, turn the
left control knob on the control panel.
The control panel shows how much the filler wire has run.
Finalize the installation:
19.
Select the shielding gas and attach the gas cylinder to the wire feeder.
20.
Press Gas test to flush the former shielding gas from the system.
You can also use this button to test that the gases flow through the system properly.
© Kemppi
40
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
