Table of Contents
Advertisement
8.
Attach the wire spool brake halves to the new wire spool by pushing them together inside the wire spool. Tighten if
necessary.
The spool brake is equipped with an optional wire tensioning feature, which keeps the wire feed steady in short
repeated welds and with heavy wire spools. To enable wire tensioning, attach the spool brake hub to the wire spool
so that the tightening knob is on the right, seen from the front.
9.
Lower the wire spool to its socket.
Ensure that the wire spool is facing the right direction, the filler wire running from the top of the spool to the feed
rolls.
10.
Lift the pressure handle off of the feed rolls.
Install the filler wire:
11.
Release the pressure arms to move the feed rolls apart. This opens a gap between the feed rolls.
12.
Release the filler wire end from the spool and cut off any deformed section so that the end is straight.
Ensure that the filler wire does not spill from the spool when it is released.
© Kemppi
38
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
