Table of Contents
Advertisement
3.1 X8 MIG Welder control devices
Welding with X8 MIG Welder can be controlled through three different control panels, which offer slightly different fea-
tures for adjusting the welding parameters.
The actual features vary according to the functions and usability of the control panel.
"Control Pad" below
Control Pad is a window to X8 MIG Welder: Control Pad shows you all the settings and licenses installed in the welding
system.
"Wire feeder control panel" on page 70
The control panel of the wire feeder has a one-knob navigation and push buttons for selecting parameters or values.
You can, for example, adjust the welding parameters and save settings on memory channels.
Gun remote control
With the gun remote control, you can select memory channels and WPSs, and adjust wire feed speed, fine tuning and
dynamics. For instructions on using the gun remote control, refer to Flexlite GX MIG welding gun documentation in
doc.kemppi.com.
3.1.1 Control Pad
Control Pad is a window to X8 MIG Welder: Control Pad shows you all the settings and licenses installed in the welding
system.
You can adjust the welding parameters and their values remotely with the one-knob navigation, and connect Control
Pad to any X8 MIG Welder nearby.
"Navigation" below
"Control Pad views" on page 62
Navigation
Above the display, Control Pad has three view buttons. Press these buttons to change the view on Control Pad's display.
Press the Menu button twice to open the View menu.
© Kemppi
60
X8 MIG Welder
Operating manual - EN
user-
1902370 / 2324
Advertisement
Table of Contents
