Table of Contents
Advertisement
21.
Close the top cover.
Wire spools
X8 MIG Welder has three different wire spool hub options available for different wire spools:
•
Standard spool (A)
•
Spool hub for the small wire spool (B)
>> Attach the extension pieces to the standard spool halves.
•
Spool hub for the wire spool with a large center hole (C)
All parts are delivered with the wire feeder.
Loosen and pull the spool halves to detach them.
2.3.6 Attaching interconnection cable to strain relief
To ease the installation of the interconnection cable and to prevent any unnecessary strain on the cable connectors,
attach both ends of the interconnection cable bundle to a strain relief.
Proceed as follows:
1.
Attach the strain relief holder to the transportation handle at the rear of the power source. Fasten the strain relief
holder with a bolt from below.
2.
Take the power source end of the interconnection cable and insert the strain relief pin to the strain relief holder.
If the wire feeder is detached from the power source, insert the strain relief pin to the holder from below.
© Kemppi
41
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
