Table of Contents
Advertisement
4.
Place the upper part of the gas cylinder cart on the wheel set, and push it down until the claw fastens over the trans-
portation handle.
5.
Attach the upper part of the gas cylinder cart to the wheel set with two bolts (1) and washers (2, 3) from both sides.
6.
Attach the bottom of the gas cylinder cart to the wheel set with six bolts (1) and washers (2, 3).
>> The gas cylinder cart bottom has two alternative settings (the lower setting described in the figure). The higher
setting gives a better ground clearance, but you must lift the gas cylinder higher.
© Kemppi
28
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
