Table of Contents
Advertisement
2.3 Wire feeder installation
This chapter describes the wire feeder installation.
For wire feeder cable connections, see "Installing interconnection cable" on page 43. For information on operating the
wire feeder, see "Wire feeder control panel" on page 70.
Welding quality and efficiency are greatly dependent on the consumable parts used on the wire line. These include
the wire guide tubes, feed rolls, wire liners, gas nozzles and contact tips. Always ensure that you are using the correct
consumable parts suitable for the filler wire size and material.
For more information, visit Kemppi consumable kit selection site at kitselect.kemppi.com.
"Installing wire feeder" below
The installation of the Wire Feeder Rotating Plate and Double Wire Feeder Rotating Plate is identical, as is installing one
or two wire feeders.
"Installing welding gun holder" on page 33
"Replacing feed rolls" on page 33
"Replacing wire guides" on page 36
"Changing wire spool" on page 36
"Attaching interconnection cable to strain relief" on page 41
2.3.1 Installing wire feeder
The installation of the Wire Feeder Rotating Plate and Double Wire Feeder Rotating Plate is identical, as is installing one
or two wire feeders.
Install the wire feeder on the power source with a Wire Feeder Rotating Plate. To install two wire feeders, use a Double
Wire Feeder Rotating Plate.
To set up the system for double wire feeder configuration, you need assembly parts (Connecting sleeve holder and
Cooling hose assy KV200 female-female).
Proceed as follows:
1.
Place the wire feeder rotating plate or double rotating plate on top of the power source, with the orange claw at
the rear of the unit.
© Kemppi
31
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
