Welding Programs In Control Pad - Kemppi X8 MIG Welder Operating Manual

Panel settings
Panel settings display Control Pad's mechanical settings:
1. PIN lock
>> Lock Control Pad with a 4-digit PIN code. When PIN lock is on, PIN code is required every time when Control
Pad is turned on. PIN lock does not prevent welding.
2. Change PIN code
>> Change the 4-digit PIN code.
3. Language
>> Choose the language out of 13 options.
4. Basic/Advanced mode
>> (User interface mode)
5. Brightness
>> Brightness of the display in percents.
6. Power usage
>> The settings available are Minimum, Economic and Normal.

Welding programs in Control Pad

Select the mode in Settings > Mode. Then select one of the welding programs in Welding program. The MMA and
GOUGING modes have one welding program each, and you can adjust their settings in Parameters.
Figure: The Welding program menu in Settings:
You can use the filters under Welding program to filter the welding programs on the selection list. You can also select
the needed welding program without using the filters.
The parameters available in Settings vary according to the selected welding process and the Basic/Advanced mode.
Welding program menu
The filters under Welding program are:
1. Material
>> Select the material of the welding piece.
2. Wire material
3. Wire diameter
4. Shielding gas
© Kemppi
68
X8 MIG Welder
Operating manual - EN
1902370 / 2324