Wire Feeder Connection - Kemppi HiArc M 350A Operating Manual

2.5.2 Wire feeder connection

The HiArc power source is designed to be used with the HF10 wire feed unit.
To connect the HF10 wire feeder unit to the power source, complete the following steps:
EN
1. Attach the HF10 wire feed unit power cable to the + connector of the HiArc power
source. Hand tighten the connector with a clockwise push and twist action to lock.
2. Attach the HF10 wire feed unit control cable plug to the control socket of the power
source.
3. Connect the shielding gas hose to the gas bottle or to the shielding gas distribution
system.
Please read carefully the wire feeder installation and operation instructions in the Kemppi
NOTE!
HF10 operating manual.
Normally the wire feeder should be connected to the plus pole. However, with some filler
NOTE!
wires and shielding gases, you should connect the feeder to the minus pole, and the earth return
cable to the plus pole.
8
HiArc M 350A, M 500A
3.
2.
1.