Table of Contents
Advertisement
5.
Place the feed rolls back to their places. Align the cut on a drive roll's bottom with the pin on the drive shaft.
6.
Reattach the mounting pins to lock the drive and pressure rolls to their places. Align one of the cuts on the bottom
of the pressure rolls' mounting pin with the stud on the mount.
7.
Lower the pressure handle on the feed rolls and close the top cover.
2.3.4 Replacing wire guides
The wire feed mechanism includes two wire guide tubes. Replace them when the filler wire diameter grows or the mater-
ial changes.
1.
Inlet tube
>> Pull out the inlet tube and insert a new one. There is no additional locking.
2.
Middle tube
>> A metal piece locks the middle wire guide tube in its place. Turn the piece aside to free the middle wire guide
tube for replacement. Turn it back to lock down the new middle wire guide tube.
2.3.5 Changing wire spool
Install the welding gun to the wire feeder before installing the wire spool.
© Kemppi
36
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
