Control Pad Views - Kemppi X8 MIG Welder Operating Manual

Figure: Control Pad display with the Adjust footer / Control Pad display with the Select footer:
If the selection of the toggle button comes into effect right away, the footer command is Close. If the change comes into
effect after pressing the green button, the footer command is OK.

Control Pad views

There are three main views on Control Pad display: Channel (memory channels), Welding, and Settings. Toggle
between the views with the view buttons. The View menu inside Welding opens, when you press the Menu button
again in the Welding view.
Figure: The Channel button:
Figure: The Menu button:
Figure: The Settings button:
"Control Pad views: Welding" on the next page
"Control Pad views: Settings" on page 66
"Control Pad views: Channel" on page 69
"Control Pad views: View menu" on page 69
© Kemppi
62
X8 MIG Welder
Operating manual - EN
1902370 / 2324