Table of Contents
Advertisement
2.6 Preparing and connecting welding gun
Assemble the welding gun and connect it to the wire feeder with Kemppi Gun Adapter.
The welding gun has been preassembled by the manufacturer: the wire liner, contact tip and gas nozzle are pre-
mounted. For instructions on installing and changing Flexlite GX MIG welding gun parts, refer to userdoc.kemppi.com.
To start using the gun, proceed as follows:
1.
Check that the wire liner, contact tip and gas nozzle are suitable for the job. Change if needed. If your setup
includes a gas-cooled gun, you can also change the neck.
2.
Attach the pistol grip handle, if suitable for the job.
3.
Attach gun remote control, if suitable for the job (optional accessory).
4.
Connect the welding gun to the wire feeder: Push the welding gun connector into the wire feeder gun adapter, and
hand-tighten the collar.
5.
If your setup includes a water-cooled gun, connect the cooling hoses to the wire feeder. The coolant inlet hose is
marked with blue and the coolant outlet hose with red color.
© Kemppi
51
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
