Kemppi X8 MIG Welder Operating Manual page 65

Figure: The minimum and maximum stoppers.
The value range of the welding power and voltage graphs specified by the Welding Procedure Specification (WPS) are
displayed with a green arc between the stoppers. The stoppers are by default at the top and bottom of the specified
WPS area, but you can adjust them to your preferences: to narrow the area or to weld outside the specified area.
Figure: The minimum and maximum stoppers for WPS.
If you adjust the wire feed speed or voltage to a level outside the WPS range, the parameter graph turns red and a warn-
ing symbol appears on the display.
If you have installed WeldEye, it saves the data as unsuitable use, even if the welding job requires such values.
© Kemppi
65
X8 MIG Welder
Operating manual - EN
1902370 / 2324