Table of Contents
Advertisement
DProcess menu
If the welding program includes the DProcess process, the DProcess menu appears in the Settings view.
For more information, see "Standard MIG welding processes in X8 MIG Welder" on page 88.
Wise feature menu
Wise feature displays the Wise features available for use with the welding program.
For more information, see "Wise features" on page 95.
Trigger logic menu
Trigger logic displays the trigger logic options: 2T, 4T and WP Switch.
For more information, see "Trigger logic functions" on page 100.
Start and stop logic menu
Start and stop logic displays several options. For more information, see "Start and stop functions" on page 101.
Parameters
The parameters available vary according to the welding process used:
•
Wire feed speed
>> In addition to wire feed speed, you can adjust the minimum and maximum values of wire feed speed here.
•
Voltage
•
Fine tuning
•
Dynamics
•
Pulse current percent
•
Start power
•
Start level
•
Stop power
For more information, see the description of the processes.
System settings
The options under System settings are:
1.
Water cooling
>> Set water cooling ON, OFF or on AUTO.
>> In ON mode, the water cooling is continuous. In OFF mode, the water cooling is fully stopped. In AUTO mode,
the water cooling is on when needed.
2.
Sub feeder selection
>> Select the sub feeder you are using and its length, or the motorized gun.
3.
WF Motor warning level
>> Select a limit for the welding current. The system warns you, if the value exceeds the limit.
4.
Voltage display mode
>> Select the welding voltage: terminal or arc voltage.
5.
Safe wire inch
>> Set the Safe wire inch ON or OFF. If the Safe wire inch is ON, the wire feeder feeds maximum 5 cm of the wire, if
the arc does not ignite until then. If the Safe wire inch is OFF, the wire feeder feeds maximum 5 m of the wire.
This is to prevent the wire from hitting the welder.
6.
Voltage reduction device (VRD)
>> Switch VRD ON or OFF if you are using MMA or gouging process. VRD reduces the maximum unloaded open cir-
cuit voltage across the output terminals of the welding machine to a safe voltage.
7.
Factory reset
>> Restore the settings back to factory default settings.
© Kemppi
67
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
