Table of Contents
Advertisement
2.5 Control Pad installation
This chapter describes the Control Pad installation.
For information on operating Control Pad, see "Control Pad" on page 60.
"Wireless connection" below
Control Pad connects wirelessly to X8 Wire Feeder. If there are two wire feeders in the system, choose which one to con-
nect to. Control Pad can be connected to X8 Power Source in applications where no wire feeder is needed, such as stick
welding or gouging.
"Wired connection" on page 49
Control Pad makes a wired connection with X8 Power Source and X8 Wire Feeder. Connect Control Pad to a wired con-
nection, when wireless connection is unavailable.
"Suspending Control Pad" on page 50
2.5.1 Wireless connection
Control Pad connects wirelessly to X8 Wire Feeder. If there are two wire feeders in the system, choose which one to con-
nect to. Control Pad can be connected to X8 Power Source in applications where no wire feeder is needed, such as stick
welding or gouging.
To set up a wired connection between Control Pad and the power source or the wire feeder, see "Wired connection" on
page 49.
If Control Pad is not connected, you see this info message on the display:
Proceed as follows:
1.
To connect Control Pad wirelessly to a wire feeder or power source:
>> Press the wireless pairing button on the power source indicator panel.
© Kemppi
47
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
