Table of Contents
Advertisement
The welding power graph shows with grey raster pattern the area, where the selected values result in globular transfer.
Figure: Raster pattern in the wire feed arc.
In DPulse, WP Switch and DProcess, you can adjust two value sets: the first level and the second power level. Press the
left green button to toggle between them. Adjust the values with the control knobs. The other power level is shown
with gray line on the wire feed speed diagram.
Figure: Toggling DPulse (1) / Toggling DPulse (2).
You can specify the minimum and maximum values of the wire feed speed. They are displayed as white stoppers beside
the wire feed speed diagram.
© Kemppi
64
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
