Installation - Kemppi X8 MIG Welder Operating Manual

2. INSTALLATION

Perform this installation procedure to prepare your X8 MIG Welder for use.
Read the instructions carefully and follow them closely.
"Before installation" on the next page
Make sure to acknowledge and follow the local and national requirements on installation and the use of high voltage
units.
"Power source installation" on page 23
For power source cable connections, see "Installing interconnection cable" on page 43 and "Installing or replacing mains
cable" on page 30. For operating the power source, see "Preparing welding system for use" on page 73.
"Wire feeder installation" on page 31
This chapter describes the wire feeder installation.
"Cables installation" on page 43
For a detailed description of the power source and wire feeder cabling, see Installing interconnection cable. For a full
overview of the cabling, see Cabling diagram.
"Control Pad installation" on page 47
This chapter describes the control pad installation.
"Preparing and connecting welding gun" on page 51
Assemble the welding gun and connect it to the wire feeder with Kemppi Gun Adapter.
"Lifting X8 MIG Welder" on page 53
"Purchasing and managing welding software" on page 54
Kemppi offers a wide selection of welding software to ensure high-quality welds.
"Optional accessories" on page 55
X8 MIG Welder has several accessories to facilitate its use and improve welding quality.
© Kemppi
21
X8 MIG Welder
Operating manual - EN
1902370 / 2324