Kemppi X8 MIG Welder Operating Manual page 37

If you change the filler wire to a different diameter or material, change the feed rolls accordingly.
Proceed as follows:
Remove the wire spool:
1. Open the top cover latch.
2. Lift the top cover up.
3. Cut and file the tip of the filler wire.
The sharp cut tip of the filler wire may cause damage to the wire liner, if not filed.
4. Press Wire retract to pull back the remaining filler wire from the welding gun.
5. Push the wire spool locking cover aside.
6. Lift the wire spool from the wire feeder.
7. Loosen and pull the wire spool brake halves apart.
Install a new wire spool:
© Kemppi
37
X8 MIG Welder
Operating manual - EN
1902370 / 2324