Table of Contents
Advertisement
Proceed as follows:
1.
Detach the two screws in the front panel of the power source.
2.
Pull the front panel outwards from the lower edge.
3.
Remove the lower left cover from the rear of the power source.
4.
Push the cooler inside the power source from the opening in the front.
Do not use force, but make sure the connectors on the cooler and the power source are properly connected.
5.
Fill the coolant container with applicable coolant solution. For more information, see "Filling cooler" on page 75.
6.
Attach the two screws in the front panel of the power source.
2.2.4 Installing or replacing mains cable
The power source is supplied with a 5-meter mains cable without a plug installed.
The mains cable must be installed by an authorized electrician.
For high voltage versions, install the 6 mm
The mains cable includes the following wires:
1.
Brown: L1
2.
Black: L2
3.
Grey: L3
4.
Yellow-green: Protective earth
© Kemppi
2
cable. For multi-voltage versions, install the 16 mm
30
X8 MIG Welder
Operating manual - EN
2
cable.
1902370 / 2324
Advertisement
Table of Contents
