Table of Contents
Advertisement
2.
Push the rear axle through the opening in the bottom of the rear side of the unit and set the axle in the middle.
3.
Slide the two wheel spacers (1) onto the axle.
4.
Slide the two wheels (2) onto the axle.
5.
Slide the two washers (3) onto the axle.
6.
Slide the two retaining rings (4) on the axle, until they lock into the groove on the axle.
© Kemppi
24
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
