Table of Contents
Advertisement
>> The led on the power source begins to blink when it is searching for Control Pad.
>> The serial numbers of the nearby available wire feeders or power sources appear on Control Pad's display.
When there are wire feeders connected to the welding system, pressing the wireless pairing button allows you to con-
nect Control Pad to a wire feeder. When there are no wire feeders connected to the system, Control Pad allows you to
connect to a power source.
Figure: Connecting to wire feeder / Connecting to power source:
>> Move focus to select the connection and press the green button.
The connection list shows the serial numbers of the available wire feeders and a power source. Check the serial num-
ber on the device rating plate.
A connection forms between the wire feeder or power source and Control Pad. The led on the power source lights up
permanently.
Once you have created the connection, Control Pad tries to reconnect if you take it out of the connection distance.
Select Disconnect on Control Pad to disconnect the connection.
2.
You can also connect Control Pad to the wire feeder through the wire feeder control panel if the wire feeder is far
from the power source.
>> Go to Settings > Wireless devices > Connect. The wire feeder connects automatically to Control Pad.
3.
If the buttons of the power source and wire feeder are unreachable:
>> Go to Settings > WirelessDevicesAvailable in Control Pad.
© Kemppi
48
X8 MIG Welder
Operating manual - EN
1902370 / 2324
Advertisement
Table of Contents
