Output Settings; Tone Chorus Send - Roland Sonar V-Studio VS-700 Owner's Manual

Output Settings

Rhythm Output
Rhythm Out Assign
Specifies for each rhythm set how the direct sound will be
output.
Value:
MFX: Output in stereo through multi-effects. You can
also apply chorus or reverb to the sound that
passes through multi-effects.
L+R: Output in stereo without passing through multi-
effects.
L, R: Output in mono without passing through multi-
effects.
Tone Out Assign
Specifies how the direct sound of each tone will be output.
Value:
MFX: Output in stereo through multi-effects. You can
also apply chorus or reverb to the sound that
passes through multi-effects.
L+R: Output in stereo without passing through multi-
effects.
L, R: Output in mono without passing through multi-
effects.
* If the Rhythm Output Assign is set to anything other than
"TONE," these settings will be ignored.
* Chorus and reverb are output in mono at all times.
* The output destination of the signal after passing through
the chorus is set with the Chorus Output Select (p. 147).
Tone Out Level
Set the level of the signal that is sent to the output
destination specified by Patch/Tone Output Assign.
Value: 0–127

Tone Chorus Send

(Send Level (Output=MFX))
Specifies the level of the signal sent to the chorus for each
tone if the tone is sent through MFX.
Value: 0–127
Tone Reverb Send
(Send Level (Output=MFX))
Specifies the level of the signal sent to the reverb for each
tone if the tone is sent through MFX.
Value: 0–127
Tone Chorus Send
(Send Level (Output=non MFX))
Sets the level of the signal sent to chorus for each tone if the
tone is not sent through MFX.
Value: 0–127
Tone Reverb Send
(Send Level (Output=non MFX))
Sets the level of the signal sent to reverb for each tone if the
tone is not sent through MFX.
Value: 0–127
Creating a Rhythm Set
135