Removing The Mount; Disposal; Materials; Consumables - Kemppi Robot Gun Mount T1 Operating Manual

Table of Contents

16. REMOVING THE MOUNT

This section describes how to remove robot mount T1.

Unmounting may only be carried out by specialist personnel. Please make sure that

the shutdown procedures are strictly observed before the unmounting work begins.

Ensure this also for the components integrated into the welding system.

Risk of injury due to unexpected start-up

For the entire duration of maintenance, servicing, unmounting, and repair work, the

following instructions must be adhered to:

• Switch off the power supply.

• Cut off the compressed air supply.

• Pull the power plug.

For disposal, the locally applicable regulations, laws, provisions, standards, and guidelines

must be observed. For the welding torch system to be properly disposed of, it must be

unmounted first.

This product consists for the most part of plastics, steel, and non-ferrous metals. Steel and

non-ferrous metals can be melted down, so iron materials are almost infinitely recyclable.

The plastic materials used are marked in preparation for appropriate sorting of the materials

for later recycling.

Oils, greases, and cleaning agents must not contaminate the ground or enter the sewer

system. These materials must be stored, transported, and disposed of in suitable containers.

Please observe the relevant local regulations and the disposal instructions on the safety

data sheets supplied by the manufacturer of the consumables. Also, contaminated cleaning

tools (brushes, rags, etc.) must be disposed of in accordance with the information provided

by the manufacturer of the consumables.

The shipping packaging has been reduced to a minimum. Packaging materials are always

selected with attention to their recyclability.

Robot Gun Mount T1

1616

Table of Contents