Adding A Transformer Temperature Controller - Huawei FusionPower6000 3.0 User Manual

FusionPower6000 3.0
User Manual (Not Against a Wall)
----End

6.6.2.1 Adding a Transformer Temperature Controller

Step 1 Add a transformer temperature controller.
1.
2.
3.
Issue 03 (2023-02-08)
NO TE
Devices can be manually added or automatically discovered. After a device that can be
automatically discovered is connected to the ECC800-Pro, you do not need to manually add
the device.
● Devices that need to be manually added: transformer temperature controller, ATS, and
compensation cabinet.
● Devices that can be automatically discovered: smart ETH gateway, WiFi module, cable
inlet and bus tie cabinet (separate or combined), UPS, maintenance bypass cabinet, and
feeder cabinet.
Log in to the ECC800-Pro WebUI as an administrator.
Add a transformer temperature controller.
Table 6-1 Adding a transformer
Path Parameter
Choose Device
System Attribute
Settings >
Device Type
Device
Managemen
t and click
Add Device.
The
parameters
for adding
devices are
displayed.
Connect To
Communicati
ons Port
Device
Address
Click Test Connect to check whether the transformer temperature controller
is properly connected to the ECC800-Pro.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
Copyright © Huawei Digital Power Technologies Co., Ltd.
Setting
Select Transformer from the drop-down list
box.
Select Transformer_LD-B10 or
Transformer-ABB-SCB11-2000 from the
drop-down list box.
– If the transformer is from Huapeng,
Siemens, Aux, or Taikai, select
Transformer_LD-B10.
– If the transformer is from ABB, select
Transformer-ABB-SCB11-2000.
Select System-Device name from the drop-
down list box.
Select COM1 from the drop-down list box.
In this example, Communications Port is
set to COM1. During actual configuration,
set the communications port based on the
actual situation.
In this example, Device Address is set to 1.
During configuration, set the actual device
address.
6 FAQ
202