Table of Contents
Advertisement
FusionPower6000 3.0
User Manual (Not Against a Wall)
Step 1 Install channel steel.
Step 2 Remove the PC panels from the rear door of each UPS.
Step 3 Move the transformer cabinet and then other cabinets to the installation position
in sequence.
Step 4 Level the cabinets.
Step 5 Combine adjacent cabinets. This operation is not required for the transformer
cabinet.
Step 6 Secure each cabinet to the channel steel.
----End
4.6 Installing Enclosure Frames
Do not step on the top panels or cables on the top of cabinets.
Step 1 Remove the leftmost and rightmost top connecting kits from the cabinets of the
low-voltage system (excluding the transformer cabinet) of the FusionPower6000.
Figure 4-12 Removing the leftmost and rightmost top connecting kits
Step 2 Remove certain parts from the top of the UPS cabinet.
Figure 4-13 Removing certain parts from the top of the UPS cabinet
Issue 03 (2023-02-08)
CA UTION
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Installation and Cable Connection
100
Advertisement
Table of Contents
