Installing Compensation Modules - Huawei FusionPower6000 3.0 User Manual

FusionPower6000 3.0
User Manual (Not Against a Wall)
● One DT terminal can be crimped on each of the two sides of the copper bar.
● After connecting cables, calibrate the torque and fully tighten the bolts using a
----End

4.9 Installing Compensation Modules

● If compensation modules are delivered separately, install them onsite.
● Compensation modules must be installed in adjacent slots from top to bottom.
Step 1 Use a lifting trolley to move the compensation modules to the reserved position in
the compensation cabinet.
Step 2 Set the DIP switches on the compensation modules.
Module No.
1
2
3
4
5
Step 3 Secure the compensation modules.
Issue 03 (2023-02-08)
NO TICE
That is, two DT terminals can be crimped at one bolt.
torque wrench.
NO TICE
The corresponding numbers are 1 to 5.
Address
Position 1
ON
OFF
ON
OFF
ON
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Installation and Cable Connection
Address Address
Position 2 Position 3
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
Address
Position 4
OFF
OFF
OFF
OFF
OFF
145