Table of Contents
Advertisement
FusionPower6000 3.0
User Manual (Not Against a Wall)
2.
Step 6 Synchronize parallel parameters.
1.
2.
Step 7 Clear the EPO state of each UPS. For details, see
UPS.
Step 8 Tap Paral. Inv. ON on the LCD screen Common Functions. The system transfers
to inverter mode.
Step 9 Connect batteries to the parallel system.
1.
2.
Issue 03 (2023-02-08)
Item
Setting
Parallel ID
Number UPSs in
sequence
(example: 1, 2,
3, 4).
Requisite UPSs
Sets it based on
the actual
number of UPSs.
Redundant
Sets it based on
UPSs
the actual
number of UPSs.
Battery Settings: On the LCD, choose System Info > Settings > Battery
Settings. On the WebUI, choose Monitoring > Battery System > Running
Parameter > Battery Settings.
Table 5-2 Battery Settings
Item
Battery string
sharing
If the Inconsistent parallel param. alarm is generated, choose System Info >
Settings on the LCD and tap Parameter Sync to synchronize parameters
between UPSs in the parallel system.
Check that no alarm is generated for any UPS and perform subsequent
operations. If an alarm is generated, follow the troubleshooting suggestion to
clear the alarm first.
Check that no alarm except the No battery alarm is displayed on the LCD of
each UPS.
Turn on the battery input switch for each UPS. (If there are multiple battery
strings, turn on the switch of each battery string first, and then turn on the
general switch between the battery strings and the UPS.)
Copyright © Huawei Digital Power Technologies Co., Ltd.
Description
-
– In a parallel system, the two
parameters must be set to the
same values for all UPSs.
– The total number of UPSs in a
parallel system is the sum of
Requisite UPSs and Redundant
UPSs.
Setting
Description
Set this
If the parallel system shares one
parameter as
battery string, set this parameter to
required.
Enable.
If each UPS uses an independent
battery string, set this parameter to
Disable.
5 Power-On Commissioning
6.5 Clearing the EPO State for a
170
Advertisement
Table of Contents
