Huawei FusionPower6000 3.0 User Manual page 40

FusionPower6000 3.0
User Manual (Not Against a Wall)
Monitoring
Device
Temperature
controller
Automatic
transfer switch
(ATS) controller
Centralized
monitoring
module
Compensation
cabinet controller
Monitoring
interface card
Smart ETH
gateway
ECC800-Pro
PAD
The FusionPower6000 can be connected to the management system in the
following ways to implement remote management:
●
●
●
Issue 03 (2023-02-08)
Cabinet
Transformer cabinet
Cable inlet and bus tie
cabinet/Bus tie cabinet
Cable inlet and bus tie
cabinet/Cable inlet
cabinet/Bus tie
cabinet, maintenance
bypass cabinet, and
feeder cabinet
Compensation cabinet
UPS
Cable inlet and bus tie
cabinet/Cable inlet
cabinet, maintenance
bypass cabinet, and
feeder cabinet
Maintenance bypass
cabinet
Maintenance bypass
cabinet
Method 1: Connect to the NetEco over a LAN switch to implement remote
management. A license is required to implement the iPower intelligent
features.
Method 2: Connect to the DC Manager through a wired network to remotely
view the device status.
Method 3: Connect to the DC Manager through 4G wireless communication
to remotely view the device status.
Copyright © Huawei Digital Power Technologies Co., Ltd.
Description
Collects the transformer winding temperature;
connects to the ECC800-Pro over an RS485 port.
In the 2N scenario, the ATS implements the bus tie
control function to control the automatic switchover
between two FusionPower6000 cable inlet switches
and one bus tie switch. The ATS connects to the
ECC800-Pro over an RS485 port.
Collects the AC voltage, current, copper bar contact
temperature, switch status, and branch monitoring
module signals; connects to the smart ETH gateway
over a WAN port.
Collects the voltage, current, and communication
status of compensation modules; connects to the
ECC800-Pro over an RS485 port.
Allows you to view the operating status and set
parameters; connects to the smart ETH gateway
over an FE port.
Cascades the centralized monitoring modules and
UPS monitoring interface cards over PoE ports;
connects to the ECC800-Pro over an FE port.
Collects the FusionPower6000 operating signals and
uploads the signals to the management system.
Connects to the WLAN of the ECC800-Pro and
displays the operating status of the
FusionPower6000 on the FusionModule app.
2 Product Overview
33