Table of Contents
Advertisement
FusionPower6000 3.0
User Manual (Not Against a Wall)
4.8.1 Cabinet Cable Routes
● Cables between cabinets should be routed behind the door headers of
● When routing cables, open the door panel of the enclosure frame and remove
● Keep cables at least 30 mm away from heat-generating components or heat
● Bind cables of the same type together. When routing cables of different types,
● Pre-route cables before installing enclosure frames and copper bars.
Figure 4-50 Cable routes for the transformer cabinet
(A) Front door closed
(2) Signal cables
Issue 03 (2023-02-08)
NO TICE
enclosure frames.
the protective cover. After cable routing is complete, install the protective cover
and close the door panel of the enclosure frame.
source areas.
ensure that they are at least 30 mm away from each other.
NO TE
If installed on channel steel, the transformer cabinet supports top and bottom cabling.
Choose either one based on the site requirements.
Copyright © Huawei Digital Power Technologies Co., Ltd.
(B) Rear door opening
(3) Ground cable
4 Installation and Cable Connection
(1) Power cable
130
Advertisement
Table of Contents
