Huawei FusionPower6000 3.0 User Manual page 71

FusionPower6000 3.0
User Manual (Not Against a Wall)
Table 2-9 SW button description
Function
Description
Wireless
network RF_Z
(802.15.4)
pairing
WLAN enabling
Restoring the
default IP
address, factory
settings, and
user information
Table 2-10 PSU indicator description
Indicator
Issue 03 (2023-02-08)
Operation Description
In non-wireless network (802.15.4)
pairing mode, press and hold the
button for 3s to 5s to enter the
wireless network pairing mode.
In wireless network (802.15.4)
pairing mode, press and hold the
button for 3s to 5s to exit the
pairing mode; or the system
automatically exits the pairing mode
after 30 minutes without pressing
the button.
Hold down the button for more than
8s to erase network parameters. The
system automatically enters the
wireless network pairing mode.
Hold down the button for 1s to
enable WLAN.
Press and hold down the button for
1 minute.
Color Name
Green Power
indicator
Copyright © Huawei Digital Power Technologies Co., Ltd.
Status Description
Steady on The PSU has input power.
Off The PSU has no input power or
is faulty.
Blinking at The PSU is being queried (the
long indicator blinks at 0.5 Hz, on
intervals for 1s and then off for 1s).
Blinking at The PSU application program is
short being loaded (the indicator
intervals blinks at 4 Hz, on for 0.125s
and then off for 0.125s).
2 Product Overview
Indicator Status
The RF_Z indicator is
blinking at super
short intervals.
The RF_Z indicator is
blinking at long
intervals.
The RF_Z indicator is
blinking at super
short intervals.
-
-
64