Table of Contents
Advertisement
FusionPower6000 3.0
User Manual (Not Against a Wall)
●
●
●
●
Special requirements for lead-acid batteries:
When the battery temperature exceeds 60°C, check whether the electrolyte leaks.
If the electrolyte leaks, take proper measures promptly.
If the electrolyte leaks, follow the instructions of the battery manufacturer or use
sodium bicarbonate (NaHCO
electrolyte.
Battery Room Fire Safety
The fire safety of the battery room must comply with local laws and regulations
as well as applicable standards such as NFPA 855-2020, NEN-1010, or GB 50016,
and meet the following requirements:
●
●
●
●
●
●
●
●
Issue 03 (2023-02-08)
Inhalation: Evacuate from contaminated areas, get fresh air immediately, and
seek immediate medical attention.
Eye contact: Immediately wash your eyes with water for at least 15 minutes,
do not rub your eyes, and seek immediate medical attention.
Skin contact: Wash the affected areas immediately with soap and water and
seek immediate medical attention.
Intake: Seek immediate medical attention.
NO TICE
NO TICE
An independent battery room must be deployed.
The battery room must not be located in environments where explosive gases
may exist or be released.
The battery room must not be located near or under areas with water
leakage risks, such as water reservoirs, water landscapes, and water towers.
The indoor layout of batteries should comply with local fire protection laws
and regulations in aspects such as production scenarios and the safe distance
and layout of buildings and materials.
Do not store combustible materials in the battery room. Keep such materials
at least 3 m away from the battery room.
A battery room deployed outdoors should be at least 3.0 m away from the
following places: restricted areas, combustible warehouses, dangerous goods,
high-stacking warehouses, power infrastructure, public roads, and buildings.
The battery room should be isolated from the adjacent area by fire
compartmentation. Holes should be sealed by firestop material. The fire
resistance and thermal insulation capabilities should be the same as that of
the partition wall.
The battery room should be equipped with fire extinguishers filled with
halogenatedane, heptafluoropropane, perfluorohexanone, carbon dioxide, or
dry powder. Each fire protection unit should be equipped with at least two fire
extinguishers, which should be checked and replaced periodically.
Copyright © Huawei Digital Power Technologies Co., Ltd.
) or sodium carbonate (Na
3
1 Safety Information
CO
) to neutralize the
2
3
11
Advertisement
Table of Contents
