Table of Contents
Advertisement
FusionPower6000 3.0
User Manual (Not Against a Wall)
2.
3.
4.
Figure 4-6 Installing an expansion sleeve
(1) M12x60 bolt
(4) Expansion sleeve
Step 3 If top outlet kits are provided for the UPSs, remove the PC panels from the rear
door of each UPS. Skip this step if top outlet kits are not configured.
1.
2.
Issue 03 (2023-02-08)
Partially tighten the expansion bolt and vertically insert it into the hole. Knock
the expansion bolt using a rubber mallet until the expansion sleeve is fully
inserted into the hole.
Tighten the expansion bolt.
Remove the bolt, spring washer, and flat washer.
Remove the rear door panel from the UPS cabinet.
Remove the plastic rivets and PC panels.
Copyright © Huawei Digital Power Technologies Co., Ltd.
(2) Spring washer
(5) Expansion nut
4 Installation and Cable Connection
(3) Flat washer
(6) Concrete floor
96
Advertisement
Table of Contents
