Ecc800 Webui Operations; Setting The Date And Time; Adding A Device - Huawei FusionPower6000 3.0 User Manual

FusionPower6000 3.0
User Manual (Not Against a Wall)
●
Step 4 Start the inverter.
----End

6.6 ECC800 WebUI Operations

6.6.1 Setting the Date and Time

Procedure
Step 1 Choose System Settings > System Parameters > Time.
Step 2 Set the time zone, date, and time, or click Obtain Local Time. Then, click Submit.
Step 3 (Optional) If you want to use the NTP server for time synchronization, select NTP
server sync. Set NTP primary server IP, Whether the NTP master server is
authenticated, Key ID, and Key, and click Test to check whether the test is
successful. Set NTP backup server IP, Whether the NTP backup server is
authenticated, Key ID, and Key, and click Test to check whether the test is
successful. Enter Port number and Sync interval (min), and click Submit.
----End

6.6.2 Adding a Device

Step 1 Choose System Settings > Device Management > Add Device.
Step 2 After a device is added, the details about the device connected to the
FusionPower6000 are displayed.
Figure 6-4 Adding a device
Issue 03 (2023-02-08)
Choose System Info > Alarms > Active Alarms to check that the EPO alarm
has been cleared.
On the WebUI
Choose Home > Active Alarm to check that the EPO alarm has been cleared.
Copyright © Huawei Digital Power Technologies Co., Ltd.
6 FAQ
201