Table of Contents
Advertisement
FusionPower6000 3.0
User Manual (Not Against a Wall)
Step
Operation
Setting
NetEco
communicat
ions
parameters
Add Devices
Automaticall
y
discovering
devices
Adding a
transformer
temperature
controller
Adding an
ATS
Issue 03 (2023-02-08)
Parameter
Server IP
Port number
-
Device
Attribute
Device Type
Connect To
Communicat
ions Port
Device
Address
Device
Attribute
Copyright © Huawei Digital Power Technologies Co., Ltd.
Setting
Set this parameter based on the site
plan.
Set this parameter based on the site
plan.
The following devices can be
automatically discovered: smart ETH
gateway, WiFi module, cable inlet
and bus tie cabinet (separate or
combined), UPS, maintenance bypass
cabinet, and feeder cabinet.
Select Transformer from the drop-
down list box.
Select Transformer_LD-B10 or
Transformer-ABB-SCB11-2000 from
the drop-down list box.
● If the transformer is from
Huapeng, Siemens, Aux, or Taikai,
select Transformer_LD-B10.
● If the transformer is from ABB,
select Transformer-ABB-
SCB11-2000.
Select System-Device name from the
drop-down list box.
Select COM1 from the drop-down list
box. In this example,
Communications Port is set to
COM1. During actual configuration,
set the communications port based
on the actual situation.
In this example, Device Address is
set to 1. During configuration, set the
actual device address.
Select ATS from the drop-down list
box.
5 Power-On Commissioning
Description
After the
setting is
complete,
click Test
Connect to
check
whether the
link is
successfully
set up.
-
Skip this
step if the
conditions
for powering
on the
transformer
temperature
controller
are not met.
After the
system is
powered on,
add devices
and set the
layout by
referring to
6.6.2.1
Adding a
Transformer
Temperatur
e Controller
and
6.6.4
Creating a
FusionPowe
r6000 Plan
View.
-
180
Advertisement
Table of Contents
