Show Diffserv Service - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Non-Conform
DSCP Value
Non-Conform IP
Precedence
Value
Policing Style
Redirect
If the Policy Name is not specified this command displays a list of all defined DiffServ
policies. The following fields are displayed:
Policy Name
Policy Type
Class Members

13.6.4 show diffserv service

This command displays policy service information for the specified interface and
direction. The
the system.
Format
Mode
DiffServ Admin
Mode
Interface
Direction
Operational
Status
13-26
This field displays the DSCP mark value if the non-conform
action is set-dscp-transmit.
This field displays the IP Precedence mark value if the non-
conform action is set-prec-transmit.
This field denotes the style of policing, if any, used (simple).
Forces a classified traffic stream to a specified egress port
(physical port). This can occur in addition to any marking or
policing action. It may also be specified along with a QoS
queue assignment.
The name of this policy. (The order in which the policies are
displayed is not necessarily the same order in which they
were created.)
The policy type (Only inbound is supported).
List of all class names associated with this policy.
parameter specifies a valid unit/slot/port number for
<unit/slot/port>
show diffserv service <unit/slot/port> in
Privileged EXEC
The current setting of the DiffServ administrative mode. An
attached policy is only in effect on an interface while Diff-
Serv is in an enabled mode.
Valid slot and port number separated by forward slashes.
The traffic direction of this interface service.
The current operational status of this DiffServ service inter-
face.
v1.0, March 2006
Quality of Service (QoS) Commands