System Information And Statistics Commands; Show Arp Switch; Show Eventlog; Section 18.1 "System Information And Statistics Commands - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

18.1 System Information and Statistics Commands

This section describes the commands you use to view information about system features,
components, and configurations.

18.1.1 show arp switch

This command displays connectivity between the switch and other devices. The Address
Resolution Protocol (ARP) cache identifies the MAC addresses of the IP stations
communicating with the switch.
Format
Mode
MAC Address
IP Address
Interface

18.1.2 show eventlog

This command displays the event log, which contains error messages from the system.
The event log is not cleared on a system reset. The [
Format
Mode
File
Line
Task Id
Code
Time
Unit
Note: Event log information is retained across a switch reset.
18-2
show arp switch
Privileged EXEC
A unicast MAC address for which the switch has forwarding
and/or filtering information. The format is 6 two-digit hexa-
decimal numbers that are separated by colons, for example
01:23:45:67:89:AB
The IP address assigned to each interface.
Valid slot and port number separated by forward slashes.
show eventlog [unit]
Privileged EXEC
The file in which the event originated.
The line number of the event
The task ID of the event.
The event code.
The time this event occurred.
The unit for the event.
v1.0, March 2006
] is the switch identifier.
unit
System Maintenance Commands