Snmp Configuration Commands; Snmp-Server; Section 10.1 "Snmp Configuration Commands - NETGEAR ProSafe FSM7326P Cli Reference Manual

This section describes the SNMP commands available in the 7300S Series Stackable
Switch CLI. You can configure the switch to act as a Simple Network Management
Protocol (SNMP) agent so that it can communicate with SNMP managers on your
network.
The SNMP Commands section contains the following topics:
• Section 10.1 "SNMP Configuration Commands" on page 10-1
• Section 10.2 "SNMP Show Commands" on page 10-10
The commands in this section are in one of two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.

10.1 SNMP Configuration Commands

This section describes the commands you use to configure SNMP on switch.

10.1.1 snmp-server

This command sets the name and the physical location of the switch, and the organization
responsible for the network. The range for
alphanumeric characters.
Default
Format
Mode
SNMP Commands
,
<name>
none
snmp-server {sysname <name> | location <loc> |
contact <con>}
Global Config
v1.0, March 2006
Chapter 10
SNMP Commands
and is from 1 to 31
<loc> <con>
10-1