Reload; Show Slot - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
17.1.10.1 no set slot power
This command unconfigures the power mode of the slot(s) and prohibits power from being
supplied to a card located in the slot. If you specify
to all slots, otherwise the command prohibits power to the slot identified by
.
port>
Use this command when installing or removing cards. If a card or other module is present
in this slot, power is prohibited to the contents of the slot. If the slot is empty, power is
prohibited to any card inserted into the slot.
Format
Mode

17.1.11 reload

This command resets the entire stack or the identified
identifier. The system prompts you to confirm that you want to reset the switch.
Format
Mode

17.1.12 show slot

This command displays information about all the slots in the system or for a specific slot.
Format
Mode
Slot
Slot Status
Admin State
Power State
Configured Card
Model Identifier
Pluggable
17-6
no set slot power [<unit/slot/port> | all]
Global Config
reload [unit]
Global Config
show slot [unit/slot/port]
User EXEC
The slot identifier in a <
This field indicates whether the slot is empty, full, or has
encountered an error.
This field displays the slot administrative mode as enabled or
disabled.
This field displays the slot power mode as enabled or dis-
abled.
The model identifier of the card preconfigured in the slot.
Model Identifier is a 32-character field used to identify a
card.
This field indicates whether cards are pluggable or non-plug-
gable in the slot.
v1.0, March 2006
, the command prohibits power
[all]
The
[unit]. [unit]
> format.
unit/slot/port
Stacking Commands
<unit/slot/
is the switch