Ip Route Default - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
The following must be present before the static routes are visible:
• Enable ip routing globally.
• Enable ip routing for the interface.
• The associated link must also be up.
Default
Format
Mode
14.2.4.1 no ip route
This command deletes all next hops to a destination static route. If you use the
<nextHopRtr>
preference value of the static route is reset to its default.
Format
Mode

14.2.5 ip route default

This command configures the default route. The value for
address of the next hop router. The
Default
Format
Mode
14.2.5.1 no ip route default
This command deletes all configured default routes. If the optional
parameter is designated, the specific next hop is deleted from the configured default route
and if the optional preference value is designated, the preference of the configured default
route is reset to its default.
Format
Mode
Routing Commands
preference - 1
ip route <ipaddr> <subnetmask> <nextHopRtr>
[<preference>]
Global Config
parameter, the next hop is deleted. If you use the
no ip route <ipaddr> <subnetmask> [{<nextHopRtr> |
<preference>}]
Global Config
<preference>
preference - 1
ip route default <nextHopRtr> [<preference>]
Global Config
no ip route default [{<nextHopRtr> | <prefer-
ence>}]
Global Config
v1.0, March 2006
<preference>
<nextHopRtr>
is an integer value from 1 to 255
<nextHopRtr>
value, the
is a valid IP
14-9