Mac Address And Mac Database Commands; Network Mac-Address - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
For each configured server:
IP Address
Address Type
Priority
Version
Port
Last Attempt
Time
Last Attempt
Status
Total Unicast
Requests
Failed Unicast
Requests

4.4 MAC Address and MAC Database Commands

This section describes the commands you use to configure and view information about the
system MAC address and the MAC address table.

4.4.1 network mac-address

This command sets locally administered MAC addresses. The following rules apply:
• Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally
administered (b'0') or locally administered (b'1').
• Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an
individual address (b'0') or a group address (b'1').
• The second character, of the twelve character macaddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
Format
Mode
4-14
IP Address of configured SNTP Server.
Address Type of configured SNTP server.
IP priority type of the configured server.
SNTP Version number of the server. The protocol version
used to query the server in unicast mode.
Server Port Number
Last server attempt time for the specified server.
Last server attempt status for the server.
Number of requests to the server.
Number of failed requests from server.
network mac-address <macaddr>
Privileged EXEC
v1.0, March 2006
Port and System Setup Commands