This section describes the routing commands available in the 7300S Series Stackable
Switch CLI.
This section contains the following topics:
•
Section 14.1 "Address Resolution Protocol (ARP) Commands" on page 14-1
•
•
•
•
page 14-25
•
•
The commands in this section are in one of two functional groups:
•
Show commands are used to display switch settings, statistics and other information.
•
Configuration Commands are used to configure features and options of the switch. For
every configuration command there is a show command that will display the
configuration setting.
14.1 Address Resolution Protocol (ARP) Commands
This section describes the commands you use to configure ARP and to view ARP
information on the switch. ARP associates IP addresses with MAC addresses and stores
the information as ARP entries in the ARP cache.
14.1.1 arp
This command creates an ARP entry. The value for
device on a subnet attached to an existing routing interface.
address for that device.
Routing Commands
Routing Commands
<ipaddress>
v1.0, March 2006
Chapter 14
is the IP address of a
is a unicast MAC
<macaddr>
14-1