Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
15.1.2.1 no set igmp interfacemode
This command disables IGMP Snooping on all interfaces.
Format
Mode
15.1.3 set igmp fast-leave
This command enables or disables IGMP Snooping fast-leave admin mode on a selected
interface or VLAN. Enabling fast-leave allows the switch to immediately remove the layer
2 LAN interface from its forwarding table entry upon receiving an IGMP leave message
for that multicast group without first sending out MAC-based general queries to the
interface.
You should enable fast-leave admin mode only on VLANs where only one host is
connected to each layer 2 LAN port. This prevents the inadvertent dropping of the other
hosts that were connected to the same layer 2 LAN port but were still interested in
receiving multicast traffic directed to that group. Also, fast-leave processing is supported
only with IGMP version 2 hosts.
Default
Format
Modes
15.1.3.1 no set igmp fast-leave
This command disables IGMP Snooping fast-leave admin mode on a selected interface.
Format
Modes
IGMP Snooping Commands
no set igmp interfacemode
Global Config
disabled
set igmp fast-leave <vlanId>
Interface Config
VLAN Mode
no set igmp fast-leave <vlanId>
Interface Config
VLAN Mode
v1.0, March 2006
15-3