Show Serviceport - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Locally
Administered
MAC Address
MAC Address
Type
Network
Configuration
Protocol Current
Java Mode
Web Mode

3.1.8 show serviceport

This command displays service port configuration information.
Format
Mode
IP Address
3-4
If desired, a locally administered MAC address can be con-
figured for in-band connectivity. To take effect, 'MAC
Address Type' must be set to 'Locally Administered'. Enter
the address as twelve hexadecimal digits (6 bytes) with a
colon between each byte. Bit 1 of byte 0 must be set to a 1
and bit 0 to a 0, i.e. byte 0 should have the following mask
'xxxx xx10'. The MAC address used by this bridge when it
must be referred to in a unique fashion. It is recommended
that this be the numerically smallest MAC address of all ports
that belong to this bridge. However it is only required to be
unique. When concatenated with dot1dStpPriority a unique
BridgeIdentifier is formed which is used in the Spanning Tree
Protocol.
Specifies which MAC address should be used for in-band
connectivity. The choices are the burned in or the Locally
Administered address. The factory default is to use the
burned in MAC address.
Indicates which network protocol is being used. The options
are bootp | dhcp | none.
Specifies if the switch should allow access to the Java applet
in the header frame. Enabled means the applet can be viewed.
The factory default is disabled.
Specifies if the switch should allow access to the Web Inter-
face.
show serviceport
Privileged EXEC
The IP address of the interface. The factory default value is
0.0.0.0
v1.0, March 2006
Administrative Access Commands